For all of our loyal followers, high-powered Supras are something familiar and lauded. If you track the Supra scene you will have undoubtedly come across the work of Dana Westover, owner of Virtual Works Racing in Las Vegas, Nevada. His personal Supra is back with a new look and a new dyno run of 1,308 whp.
The story behind this blue bomber started in 2001 when Dana purchased the vehicle. At that time all he wanted was an 11-second daily driver-that's not too much to ask, is it? It was a fleeting thought since two weeks later the stock turbos went out. It was at that moment the Virtual Works turbo kit was conceived. Dana built a better turbo kit and then needed a fuel system, so he built that too. He then tooled around with that setup for month until the transmission started to slip.
With loads of horsepower on tap transferring it to the ground requires a heavy-duty transmission and Dana did not want to hassle with fortifying the factory transmission. Knowing the capabilities of the TH400, Dana elected to install one in his Supra. With the help from Matt at UPFD, who supplied the flywheel and adapter plate for the TH400, Dana made new transmission mounts for the automatic transmission. A new driveshaft also had to be custom made to connect the auto to the TRD limited-slip rearend.
What do you do once you have a turbo kit, fuel system and new tranny? Install a nitrous system of course. This bright idea landed Dana with a blown motor a mere one week later. Enter Adam Dahl of West Coast Racing Engines. Adam and Dana had spent countless nights at the machine shop figuring out the right parts to use to make these motors last.
Any professional engine builder will tell you a strong reliable engine requires a good foundation. Fortunately for Dana, the 2JZ block is built like a rock and has been known to handle over 800 horses with the factory bottom end. Generating another 500 horsepower beyond that may lead you to believe that it would require a higher level of engine fortification. But surprisingly enough we were astonished to find out that the bottom end remains fairly stock with the exception of the Carrillo connecting rods and the .020-over Wiseco 8.5:1 compression pistons. Dana is still using a stock crankshaft but did upgrade to Pro-Gram billet main caps with ARP hardware for added strength.
Dana is not using a fancy stroker crankshaft or large-bore pistons, just the basics and that formula has served him well. Hell, he's still using a stock head gasket! Dana probably lives by the mantra, "If it's not broken, why fix it?" You can't blame him since the formula has been used on several cars Virtual Works has built, each generating over 1,000 horsepower. To handle severe boost duty the block was machined to accept ARP 1/2-inch head studs. When you are talking about 40-plus psi of boost and a healthy dose of nitrous on top of that you better make sure the head stays on the block.
To create a feast you need the right ingredients but you still need a chef to put it all together. Once again, Dana enlisted the help of Adam Dahl of West Coast Racing Engines in Las Vegas, Nevada to balance and blueprint the bottom end. To ensure the engine would survive a grenade being thrown at it, Adam checked and rechecked all clearances before any assembly began. Once everything was in order the components were all inspected and massaged one last time before Adam started the assembly process using Clevite 77 bearings.